Thermal Energy Transfer Experiments

Heat Capacity Experiment

Two ways in which heat transfer changes materials are by changing the temperature of an object and by changing the state of an object.

Equipment

This diagram shows the simple electrical heater method of finding the specific heat capacity, c, of a material.

Equipment 2

Make sure that the heater is fully submerged into the material and that you check the mass of the block, m, with a balance.
There should be an ammeter and a voltmeter in the electrical circuit to make sure that the current and p.d. for the heater do not change.
The thermometer measures the initial temperature, T₁, of the material and the temperature after every minute.

Method

If you record the temperature at the start and after every minute, you can plot a temperature-time graph.
The graph will be shallow at first because it takes time for the block to heat the thermometer.
Once the graph has got to its steepest, you can draw the tangent to the curve.

Result

The input power of the heater, IV, must equal mc × gradient.
So the specific heat capacity can be found by c = IV/mass × (temperature-time graph gradient).
This result ignores the effect of the apparatus heating the rest of the room. It also ignores the fact that the heating effect is not constant throughout the experiment.

Method of Continuous Flow

A much more accurate way of finding the specific heat capacity of a fluid is the method of continuous flow.

Apparatus

By using apparatus as shown in the diagram, you can measure the temperature at the left hand thermometer, T_a, and at the right hand thermometer, T_b.
When the electrical heater is switched on, T_b increases until thermal equilibrium is reached.

Equation

At this point, the heat energy supplied by the heater per unit time is equal to the sum of the internal energy gained by the water plus the heat energy lost by the water to the surroundings.
- V₁ I₁ = m₁ c_water (T_b - T_a) + H
- Where m₁ is the mass of water passing through the apparatus per unit time.

Second equation

If the flow rate is changed and the electrical heater parameters changed so that the start and finish temperatures remain constant, then we get a second equation:
- V₂ I₂ = m₂ c_water (T_b - T_a) + H.
As the temperature profile of the apparatus is the same on both occasions, the heat energy supplied to the surroundings, H will be the same.

Combination

This means that equation 1 and equation 2 can be combined to give an expression for c_water
- V₂ I₂ - V₁ I₁ = (m₂ - m₁) c_water (T_b - T_a)
So c_water = (V₂ I₂ - V₁ I₁)/(m₂ - m₁)(T_b - T_a)
The advantage of this method over the ‘heater in a beaker’ method is that the heat loss to the surroundings can be factored out. This means you can get a value closer to the true value.

Types of latent heat

Most materials have two specific latent heats.
- Specific latent heat of melting (or fusion) for the solid to liquid phase transition.
- Specific latent heat of vapourisation for the liquid to gas phase transition.
In either case, the amount of heat supplied, $\Delta E = l \times \Delta m$ , where l is the specific latent heat and Δm is the mass of the material that changes phase.

1Physical Quantities & Units

1.1Physical Quantities & Units

1.1.1Use of SI Units

1.1.2SI Prefixes, Standard Form & Converting Units

1.1.3End of Topic Test - Units & Prefixes

1.1.4Avogadro's Constant

1.1.5Scalars & Vectors

2Measurement Techniques

2.1Measurement, Errors & Uncertainty

2.1.1Measuring Length, Time & Volume

2.1.2Measuring Temperature

2.1.3Circuit Measurements

2.1.4Limitation of Physical Measurements

2.1.5Uncertainty

2.1.6Estimation

2.1.7Displaying Data

2.1.8End of Topic Test - Measurements & Errors

3Kinematics

3.1Equations of Motion

3.1.1Motion in a Straight Line

3.1.2Graphs of Motion

3.1.3Bouncing Ball Example

3.1.4End of Topic Test - Motion in a Straight Line

3.1.5Acceleration Due to Gravity

4Dynamics

4.1Momentum & Newton's Laws of Motion

4.1.1Mass & Inertia

4.1.2Newton's Laws

4.1.3Momentum

4.1.4End of Topic Test - Newton's Laws & Momentum

4.1.5A-A* (AO3/4) - Newton's Third Law

4.2Non-Uniform Motion

4.2.1Projectile Motion

4.3Linear Momentum & Conservation

4.3.1Conservation of Momentum

4.4Force, Density & Pressure

4.4.1Fields

4.4.2Force in Uniform Fields

4.4.3Friction

4.4.4Buoyancy

4.4.5Terminal Speed

4.4.6End of Topic Test - Acceleration Due to Gravity

4.4.7Centre of Mass

4.4.8Forces & Equilibrium

4.4.9End of Topic Test - Scalars & Vectors

4.4.10Moments

4.4.11End of Topic Test - Moments & Centre of Mass

4.4.12Density

4.4.13Pressure

4.5Work, Energy & Power

4.5.1Work & Energy

4.5.2Power & Efficiency

4.5.3Conservation of Energy

4.5.4End of Topic Test - Work, Energy & Power

4.6Circular Motion

4.6.1Circular Motion

4.6.2Circular Motion 2

4.6.3End of Topic Test - Circular Motion

5Gravitational Fields

5.1Gravitational Fields (A2 only)

5.1.1Newton's Law

5.1.2Gravitational Field Strength

5.1.3Gravitational Potential

6Deformation of Solids

6.1Materials

6.1.1Bulk Properties of Solids

6.1.2Energy in Materials

6.1.3Young Modulus

6.1.4End of Topic Test - Materials

7Thermal Physics

7.1Thermal Physics

7.1.1Temperature

7.1.2Measuring Temperature

7.1.3Ideal Gas Law

7.1.4Ideal Gases

7.1.5Boyle's Law & Charles' Law

7.1.6Molecular Kinetic Theory Model

7.1.7Molecular Kinetic Theory Model 2

7.1.8Thermal Energy Transfer

7.1.9Thermal Energy Transfer Experiments

7.1.10End of Topic Test - Thermal Energy & Ideal Gases

7.1.11First Law of Thermodynamics

8Oscillations

8.1Simple Harmonic Motion

8.1.1Simple Harmonic Motion

8.1.2Simple Harmonic Systems

8.1.3Energy in Simple Harmonic Motion

8.1.4Resonance

8.1.5End of Topic Test - Simple Harmonic Motion

8.1.6A-A* (AO3/4) - Simple Harmonic Motion

8.1.7End of Topic Test - Gravitational Fields

8.2Waves

8.2.1Progressive Waves

8.2.2Intensity of Waves

8.2.3Wave Speed & Phase Difference

8.2.4Longitudinal & Transverse Waves

8.2.5End of Topic Test - Progressive Waves

8.2.6Electromagnetic Waves

8.2.7Doppler Effect

8.2.8Sound Waves

8.2.9Measuring Sound Waves

8.2.10End of Topic Test - Waves

8.2.11Ultrasound Imaging

8.2.12Ultrasound Imaging 2

8.3Superposition

8.3.1Stationary Waves

8.3.2Stationary Waves 2

8.3.3End of Topic Test - Stationary Waves

8.3.4A-A* (AO3/4) - Stationary Waves

8.3.5Interference

8.3.6Interference 2

8.3.7End of Topic Test - Interference

8.3.8Diffraction

8.3.9Diffraction Gratings

8.3.10End of Topic Test - Diffraction

9Communication

9.1Communication Channels

9.1.1Communication Channels

9.1.2Modulation

9.1.3Attenuation

9.2Digital Communication

9.2.1Digital & Analogue Signals

9.2.2Representing Sound

10Electric Fields

10.1Electric Fields

10.1.1Coulomb's Law

10.1.2Electric Field Strength

10.1.3Electric Field Strength 2

10.1.4Electric Potential

10.1.5End of Topic Test - Electric Fields

10.1.6A-A* (AO3/4) - Electric and Gravitational Field

10.2Capacitance

10.2.1Capacitance

10.2.2Parallel Plate Capacitor

10.2.3Energy Stored by a Capacitor

10.2.4Capacitor Discharge

10.2.5Capacitor Charge

11Current Electricity

11.1Current Electricity

11.1.1Basics of Electricity

11.1.2Mean Drift Velocity

11.1.3Current-Voltage Characteristics

11.1.4End of Topic Test - Basics of Electricity

11.1.5Resistivity

11.1.6End of Topic Test - Resistivity & Superconductors

11.1.7Power and Conservation

11.1.8Microphones

11.1.9Components

11.1.10Relays

11.1.11Strain Gauges

11.2DC Circuits

11.2.1Circuits

11.2.2Potential Divider

11.2.3Emf & Internal Resistance

11.2.4End of Topic Test - Power & Potential

12Magnetic Fields

12.1Magnetic Fields

12.1.1Magnetic Flux Density

12.1.2End of Topic Test - Capacitance & Flux Density

12.1.3Moving Charges in a Magnetic Field

12.1.4Magnetic Flux & Flux Linkage

12.1.5Electromagnetic Induction

12.1.6Electromagnetic Induction 2

12.1.7Magnetic Flux Density

12.1.8Magnetic Resonance Scanning

12.2Alternating Currents

12.2.1Alternating Currents

12.2.2Operation of a Transformer

12.2.3End of Topic Test - Electromagnetic Induction & AC

12.2.4Rectification

13Modern Physics

13.1Quantum Physics

13.1.1The Photoelectric Effect

13.1.2The Photoelectric Effect Explanation

13.1.3End of Topic Test - The Photoelectric Effect

13.1.4Collisions of Electrons with Atoms

13.1.5Energy Levels & Photon Emission

13.1.6Wave-Particle Duality

13.1.7End of Topic Test - Absorption & Emission

13.1.8Band Theory

13.1.9Diagnostic X-Rays

13.1.10X-Ray Image Processing

13.1.11Absorption of X-Rays

13.1.12CT Scanners

13.2Nuclear Physics

13.2.1Rutherford Scattering

13.2.2Atomic Model

13.2.3Isotopes

13.2.4Stable & Unstable Nuclei

13.2.5A-A* (AO3/4) - Stable & Unstable Nuclei

13.2.6Alpha & Beta Radiation

13.2.7Gamma Radiation

13.2.8Particles, Antiparticles & Photons

13.2.9Quarks & Antiquarks

13.2.10Particle Interactions

13.2.11Radioactive Decay

13.2.12Half Life

13.2.13End of Topic Test - Radioactivity

13.2.14Nuclear Instability

13.2.15Mass & Energy

13.2.16Binding Energy

13.2.17A-A* (AO3/4) - Nuclear Fusion

Jump to other topics